[Eisfair] TVH Adapter, FW/treiber fehlt

[Kay Martinen]

Hallo

> [   12.501774] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
> [   12.543140] flexcop-pci: will use the HW PID filter.
> [   12.547311] flexcop-pci: card revision 2
> [   12.564251] DVB: registering new adapter (FlexCop Digital TV device)
> [   12.591943] b2c2-flexcop: MAC address = 00:08:c9:e1:bc:27
> [   12.596458] CX24123: wrong demod revision: d9
...
> [   17.510385] mt352_read_register: readreg error (reg=127, ret==-121)
> [   17.524803] nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121)
> [   17.531367] nxt200x: Unknown/Unsupported NXT chip: 00 00 00 00 00
> [   17.548911] lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret == -121)
> [   17.581150] stv0297_readreg: readreg error (reg == 0x80, ret == -121)
> [   17.595388] mt312_read: ret == -121
> [   17.595396] b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter

/dev/dvb existiert nicht. Falls niemand eine andere Idee hat
(Firmware-paket irgendwo) konstatiere ich, es geht mit dieser Karte
schlichtweg nicht.

> 00:0a.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card (rev 02)
>         Subsystem: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card
>         Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-
>         Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
>         Interrupt: pin A routed to IRQ 17
>         Region 0: Memory at fc000000 (32-bit, non-prefetchable) [size=64K]
>         Region 1: I/O ports at 1c00 [size=32]
>         Kernel modules: b2c2_flexcop_pci

Das Problem ist AFAIR das ich nicht ein cx24123 hab/brauche sondern
cx24124 oder cx24120 o.ä.

Kay

-- 
Sent via SN (Eisfair-1)