[Eisfair_dev] Samba 4.1.0 unstable

[Marcus Roeckrath]

Hallo Fabian,

Fabian Törner wrote:

>> Ein Laser Drucker - Test steht aus.
> 
> mhh hat nicht geklappt :(
> Wollte heute was drucken - funktionierte aber nicht.

> usb 8-3: new full speed USB device using xhci_hcd and address 0
> usb 8-3: Device not responding to set address.
> usb 8-3: Device not responding to set address.
> usb 8-3: device not accepting address 0, error -71
> hub 8-0:1.0: cannot disable port 3 (err = -32)
> usb 8-3: new full speed USB device using xhci_hcd and address 0
> xhci_hcd 0000:07:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:07:00.0: WARN: short transfer on control ep
> xhci_hcd 0000:07:00.0: WARN: short transfer on control ep
> usb 8-3: New USB device found, idVendor=04e8, idProduct=300c
> usb 8-3: New USB device strings: Mfr=1, Product=2, SerialNumber=0
> usb 8-3: Product: Samsung Laser Printer ML-1200 Series
> usb 8-3: Manufacturer: Samsung Electronics Co., Ltd.
> usb 8-3: configuration #1 chosen from 1 choice
> xhci_hcd 0000:07:00.0: WARN: short transfer on control ep
> usblp0: USB Bidirectional printer dev 2 if 0 alt 0 proto 2 vid 0x04E8
> pid 0x300C
> usb 8-3: USB disconnect, address 2
> usblp0: removed

Das sieht aber nach einem USB- und nicht Samba-Problem aus.

Kabel ok?

-- 
Gruss Marcus