[fli4l] fli4l-router a?==?utf-8?Q?ls Druckserver

[Jupp Schmitts]

Ich habe hier noch ein paar technische Infos,
vielleicht hilft das weiter:

 kernel: [87818.037750] usb 1-1: new full-speed USB device number 8
using xhci_hcd
 kernel: [87818.188061] usb 1-1: New USB device found, idVendor=067b,
idProduct=2305, bcdDevice= 2.02
 kernel: [87818.188067] usb 1-1: New USB device strings: Mfr=1,
Product=2, SerialNumber=0
 kernel: [87818.188070] usb 1-1: Product: IEEE-1284 Controller
 kernel: [87818.188073] usb 1-1: Manufacturer: Prolific Technology Inc.
 mtp-probe: checking bus 1, device 8:
"/sys/devices/pci0000:00/0000:00:14.0/usb1/1-1"
 mtp-probe: bus: 1, device: 8 was not an MTP device
 systemd[1]: Created slice system-configure\x2dprinter.slice.
 systemd[1]: Starting Configure Plugged-In Printer...
 systemd[1]: Reached target Printer.
 kernel: [87818.249596] usblp 1-1:1.0: usblp1: USB Bidirectional printer
dev 8 if 0 alt 1 proto 2 vid 0x067B pid 0x2305
 kernel: [87818.249633] usbcore: registered new interface driver usblp
 mtp-probe: checking bus 1, device 8:
"/sys/devices/pci0000:00/0000:00:14.0/usb1/1-1"
 udev-configure-printer[16489]: add usb-001-008
 mtp-probe: bus: 1, device: 8 was not an MTP device
 udev-configure-printer[16489]: device devpath is
/devices/pci0000:00/0000:00:14.0/usb1/1-1
 udev-configure-printer[16489]: MFG:Hewlett-Packard MDL:HP LaserJet 5P
SERN:- serial:-
 udev-configure-printer[16489]: Printer does not have vid, pid, and
serial
 systemd[1]: configure-printer at usb-001-008.service: Control process
exited, code=exited, status=1/FAILURE
 systemd[1]: configure-printer at usb-001-008.service: Failed with result
'exit-code'.
 systemd[1]: Failed to start Configure Plugged-In Printer.


Außerdem zeit smbclient -NL fli4l, auf dem fli4l ausgeführt, die
Freigaben an, ich kann mich jedoch nicht damit verbinden und drucken.
-- 
Viele Grüße,
Jupp